top of page
How to assemble a Whoop Drone
Unbox HappyModel DiamondF4 AIO - we will use a power cable with BT2.0 connectors
1
+
-
Solder the power cable to the correct pads
Tip: thread the wires through the hole before soldering
2
snip off 2mm of silicone to reveal the wire inside
3
Tip: micro usb facing up
motors mounts also face up
M2
M4
M3
M1
Soldering to FC - red - black - yellow
4
5
vibration mounts
▾ Front
orient frame facing yourslef
-
Thread battery and motors through frame
-
Place black vibration mounts on the AIO board and slot onto frame (check orientation)
-
Screw in motors (gently)
we use phillips screws replace the original one.
Complete
Screw in the camera mount
bottom of page